My brother just became a U.S. citizen!
Inventive way to grill
the way this stump grinder grinds stumps
Write in your resume that you were 2006 Time person of the year
How traffic signs are fabricated
3 years of wear on swing set bracket
This knife-fork. I couldn’t think of a name
This museum in Austria had a small model next to the painting for blind people to feel it.
Got this message after having my phone stolen 2 weeks ago. I had it in lost mode. What should i do?
Criticize my quad
This fungus looks like a satellite
How do I remove glue from bed?
Third time it happens, filament snapped at the last 30 minutes of an 11 hour print. Im thinking its the filament getting old. Any advice?
just got my new stock. I love it but I don’t know if im gonna regret buying the black one. What do you think?
Did a small test on retraction distance with my V2. Thought I’d share
Can someone help me find this part so I can purchase it? It is the small part that goes on the handle, it recently fell off my Lexus CT 200h 2012
What caused this sudden underextusion on top?
Why am i getting bad overhangs at around 45 degrees? 195c hatchbox pla
Cura won’t let me slice it since it’s “too big” but clearly under 120 limit
The right corners are lifting up suddenly after months of no issues. I raised the height to 900 mm and it still happens
Why am I having this weird corner on the bottom? 65c 210c
Help!! I have been consistently getting this bad first layer. I tried lowering the bed but does not seem to work.
First layer looks like it has some ‘bunching up’. What causes this?
Sorry for bad quality, but why is my first later looking weird?
How can I fix this dead pixel? Its an x1 extreme 4k. Has it happened to anyone?
What motors should i get for my first drone? Ive heard good and bad from the samguk
So this is the second time the extruder gear actually rips the filament mid-print. Is this a problem with the filament or extruder gear?
Bed wont heat, whats the problem and how can I fix it?
Stringing inside the infill on my benchy, should I be concerned? What could be causing this?
print suddenly stops for a split second and continues again. this shows up on terminal
Will this sd card work with a micro sd extension?