7 images
3 images
9 images
Back of the face - the rear of the monitor and an RTL-SDR up top with an FM bandstop, and a bladeRF on the right tied into the bulkhead. Still waiting on a cable to connect RTL
Combo keyboard, left side is all storage and right is all the other stuff. Switch came off another scrapped project, with sasquatch already there.
Charge power and USB port on outside
Left side storage, right is battery, boost converter and NUC
Battery before the BMS was taped in. There are 4 wires out, 2+ and 2- as one pair goes to the switch/boost converter and the other straight to the charge port
could have protected it better, but it's already pretty safe in there.
cut acrylic off the laser table
Happy to finally see this machine at work, even though I still need to actually fabricate a table for it, and every other time using it something seems to blow up.
3 images
2 images
3 images
2 images
3 images
4 images
5 images
3 images
4 images
3 images
5 images
2 images
3 images
2 images
3 images
7 images
2 images
2 images
3 images
2 images
6 images
2 images
2 images
3 images
3 images
3 images
9 images
5 images
2 images
2 images
2 images
2 images
2 images
4 images
6 images
2 images
6 images
2 images
2 images
2 images
8 images
2 images
3 images
3 images
3 images
2 images
