Manual transmission will shift fine into 5th gear, but grinds and won’t let me engage as soon as I lift the clutch. (91 Toyota mr2 non-turbo) (s54 tranny)1yr ⋅ thesadboyz ⋅ r/MechanicAdvice
ARP head studs have very little play when hand tight. Is that normal or should I tighten them a bit with a hex key?1yr ⋅ thesadboyz ⋅ r/EngineBuilding
Valve lifter bucket is stuck. Any way to get it out? (91 mr2) (gen 2 3sgte)1yr ⋅ thesadboyz ⋅ r/EngineBuilding
Synchros are cooked. Cheaper to buy a used one or should I take it to a rebuild shop?1yr ⋅ thesadboyz ⋅ r/mr2
Took head to a machine shop and got some kind of paint all over it. Should I remove it off the intake and exhaust surface?9mo ⋅ thesadboyz ⋅ r/EngineBuilding
Gen 2 3sgte I recently bought came with ecu and wiring harness. Do I just need the 3sgte engine fuse box to swap from a 5sfe?1yr ⋅ thesadboyz ⋅ r/mr2
Oil pressure randomly drops to low while driving, is this normal? (2002 sequoia sr5) (4.7 L)3mo ⋅ thesadboyz ⋅ r/toyotasequoia
When key is twisted psi jumps to 60 and immediately drops to 20 psi. Replaced fuel pump, fuel filter, and fuel injectors. Any ideas? (98 ford ranger 2.5) crank no start6mo ⋅ thesadboyz ⋅ r/fordranger
Ran a smoke machine and found smoke leaking through these holes on the EGR Valve. Is this normal? (1991 Toyota MR2 2.2)2yr ⋅ thesadboyz ⋅ r/MechanicAdvice
Stripped rear subframe bolt hole. I’m going to attempt to re tap it, anything I should be aware of before starting? (91 mr2) (sw21)1yr ⋅ thesadboyz ⋅ r/mr2
Bleeding SW20 (5sfe), bubbles won’t stop coming out of heater core. Any idea why?2yr ⋅ thesadboyz ⋅ r/mr2
1998 Ford Ranger 2.5L v4. Truck was having acceleration problems. Decided to clean the idle air control valve. Why would someone do this?4yr ⋅ thesadboyz ⋅ r/MechanicAdvice
I dont usually watch twitch mobile, but this ad always freezes and forces you to click on their link to skip the ad.6yr ⋅ thesadboyz ⋅ r/xqcow
