Found in a commercial basement. Restricted access door doesn't stay shut and had no lock on it.3yr ⋅ Strange_Mountain2204 ⋅ r/electricians
Looking into buying a house, but would need to add a new bathroom in the basement (eventually). Here's the drain as it is now. Does this look OK? Possible to add 1 more to this for the bathroom?2yr ⋅ Strange_Mountain2204 ⋅ r/Plumbing
Anyone else do this? Stops the bit from getting locked on the mandrel3yr ⋅ Strange_Mountain2204 ⋅ r/electricians
Been in the trade a little over 13 years, any other tools I should have?3yr ⋅ Strange_Mountain2204 ⋅ r/electricians
The only 2 options at the only sink in the only bathroom at shop I was working at today.2yr ⋅ Strange_Mountain2204 ⋅ r/OSHA
Made something with no actual purpose. Makes a decent candle plate I guess. 1st time doing a glue up, 1st time using a hand planer and 1st time using a router on something other than scrap. I'm hooked!3yr ⋅ Strange_Mountain2204 ⋅ r/woodworking
Needed a bandsaw. Had one, just not the right kind so I improvised3yr ⋅ Strange_Mountain2204 ⋅ r/woodworking
Can't quite afford a planer yet, so I bought this monster bit for my homemade planing sled. Works perfect!3yr ⋅ Strange_Mountain2204 ⋅ r/BeginnerWoodWorking
Dust off ya books, let's see if anyone can spot the code violation3yr ⋅ Strange_Mountain2204 ⋅ r/electricians
Found a suicide cord in the wild. Was inside an EMS cabinet. It was tied into a terminal block with constant hot on top, and wasn't plugged into anything. Went to move it and shorted it against the cabinet. No idea what the intended setup was.3yr ⋅ Strange_Mountain2204 ⋅ r/electricians
I bought this block of marble wood about 2 weeks ago. The whole thing was sealed in wax, no splits in it at all. Removed all the wax and shaved off (2) 1/4 slices from this side. The 2 slices are still fine but the entire block is splitting like this. Why? Is this basically unusable now?3yr ⋅ Strange_Mountain2204 ⋅ r/woodworking
How to stop cuts from looking like this. Did this on a 12 32T (1 TPI?) sliding miter saw blade. I tried to slide the cut into the wood from the side, to minimize surface cutting cutting area. Waited for the saw to reach full rpms and went through as fast as the saw would allow me to.3yr ⋅ Strange_Mountain2204 ⋅ r/woodworking
Can't find a solid answer online. Are these safe to run in a closed unventilated room? Worried about carbon monoxide.3yr ⋅ Strange_Mountain2204 ⋅ r/propane
