u/phemark

17 results (0.02 seconds)

In the middle of my smart home instalation - electrical wiring, cat5e for light switches, with HDL(knx) modules, and iRidium server(for Google Home). Anything to change/improve/add, while still in progress?

5yr ⋅ ⋅

ADVERTISEMENT

This helped me set most settings on the highest value, while losing only a few fps from low settings (set <5% all to highest, and 5%+ off/low)

3yr ⋅

⋅

Why dont tourist want to use my 25/25 Safari RC? Start and end near their dome (hotel/apartment)..

3yr ⋅

⋅

Why is my electrolyzer still getting Max Pressure for a split second every few seconds, even if I have 4 pumps around it? (Added extra pumps just to test it).

1yr ⋅

⋅

This helped me set most settings on the highest value, while losing only a couple fps when compared to all lowest settings (I set <5% all to highest, and 5%+ to off/low)

3yr ⋅

⋅

In the middle of my smart home instalation - electrical wiring, cat5e for light switches, with HDL(knx) modules, and iRidium server(for Google Home). Anything to change/improve/add, while still in progress?

5yr ⋅

⋅

My devices are showing offline, however they are actually working - I have internet, and many devices connected to both APs. So why are they appearing offline, and why are no clients are being shown (although everything works fine). (Tried power cycling all devices already).

1yr ⋅

⋅

How to get 1exp? Or why do I always have xxx9 xp?

3yr ⋅

⋅

Default RED PLA that came with a printer sticks super well, but I cannot get Matte PLA to stick at all - I've been testing so many different settings for the last 2 hours (temps/brims/extrusions ets), and nothing works - please advise.What else I can try changing before binning FlashForge Matte PLA?

1yr ⋅

⋅

Is this the best signaling I can do for this station/approach? (It works, I just want to understand if this is correct approach in signalling - so far I am doing 3x signals for 2x2 merge, and then extra 4 signals for direct cross in the middle)

4yr ⋅

⋅

Default RED PLA that came with a printer sticks super well, but I cannot get Matte PLA to stick at all - I've been testing so many different settings for the last 2 hours, and nothing works - please advise.

1yr ⋅

⋅

Which incorrect setting causes these lumps? (Seems that the very outer layer curls up on every new layer, which is slightly at an angle). (P.S. If wall is at 90 degrees or lower, everything is super smooth, but seems like if wall is at more than 90 degrees then problems). Please advise.

1yr ⋅

⋅

GoPro Session time lapse in progress :)

8yr ⋅

⋅

Some images are hidden because they can no longer be found or have been removed by the file host ()