After some very appreciated angle math from another redditer I final finished the curved path!2yr ⋅ Perryk1000 ⋅ r/woodworking
40's saved my sister's jeep, mostly. Old man had a medical issue and swerved into her lane at 45mph. Rear tire went up over the fender when she tried to avoid him. Wheel, control arms and axle need to replaced. Could have been much worse.4yr ⋅ Perryk1000 ⋅ r/Jeep
Math check for the curve please. Boards are 5.5 wide with a 66 radius = 12 boards. 90 degrees / 12 boards = 7.5 degrees per board. Table saw both sides at 15 degrees will give me the 7.5 I need? Then just round it all off with a jig saw. Tips appreciated!2yr ⋅ Perryk1000 ⋅ r/woodworking
Not a jar but I think this might belong here. Wanted a tank at work so I came up with this compromise with some trimmings from my planted tank at home.4yr ⋅ Perryk1000 ⋅ r/Jarrariums
You guys make this stuff look easy. First project with a table saw is a little rough but I’m learning and trying to get comfortable with the saw.3yr ⋅ Perryk1000 ⋅ r/woodworking
