May be mundane, but I haven't dealt with stringing in quite a while, where do I start? (Prusa Mini)3yr ⋅ overseer314 ⋅ r/FixMyPrint
You don't have to believe me, but I cut this piece of stock to 100.0mm by eye. Starting off the year strong!3yr ⋅ overseer314 ⋅ r/hobbycnc
They really did a good job at making the thargoids such a horrifying encounter.5yr ⋅ overseer314 ⋅ r/EliteDangerous
Finally getting prints I'm happy to show off! Had to print this Doom Slayer that I saw on this sub3yr ⋅ overseer314 ⋅ r/ElegooMars
PTFE spray in the hot end did wonders for my extrusion! If you've got bad ender 3 extrusion you just can't figure out, give it a try!6yr ⋅ overseer314 ⋅ r/3Dprinting
I hope this is the right place, instructions say it should be in R9M ACCESS mode, but even after flashing the firmware to the r9m 2019 module, no such option appears. Transmitter is qx7 accst with r9m access mod, trying to bind to r9 sx3yr ⋅ overseer314 ⋅ r/Multicopter
Looking to put a lift on my interceptor, but the entire mustang community won't touch me. Any ideas?6yr ⋅ overseer314 ⋅ r/Battlecars
Place your bets! Am I going to the top of r/Mustang? Or r/Shittycarmods?6yr ⋅ overseer314 ⋅ r/Mustang
Left side of the print comes out pretty nice. Right side comes out like this.6yr ⋅ overseer314 ⋅ r/3Dprinting
Ordered an antique coin and got this as a freebie. Any idea when or where it's from?6yr ⋅ overseer314 ⋅ r/coins
