Bad surface finish. I assume it is because of the angle it is at. I was wondering there is something I can do about it other than supports.1yr ⋅ Ninjadragon777 ⋅ r/FixMyPrint
MK3s+ prints keep messing up and globing on the nozzle. I already cleaned the bed, recalibrated the axis, and checked the z offset. Any ideas? I know I am doing something wrong.1yr ⋅ Ninjadragon777 ⋅ r/prusa3d
Inverter (74LS04) is getting hot/burning out when pin 13 is high. Any idea?1yr ⋅ Ninjadragon777 ⋅ r/beneater
First time modding, and I think I might have installed the screen a little bit too low.2yr ⋅ Ninjadragon777 ⋅ r/Gameboy
