Quick tip - If the battery strap runs under the FC, put a piece of plastic under the FC. This will stop the velcro loop from catching on things like the SD card holder.6yr ⋅ hbgsrjnyrmeBHT ⋅ r/Multicopter
First ever FPV VRx utilising an ESP32, plus a touchpad for good measure. Shout out to butluni for the composite video library!5yr ⋅ hbgsrjnyrmeBHT ⋅ r/esp32
When a broken arm forces you to do some much needed maintenance... New arm, replaced broken Rx antenna, replace damaged pod, bind to 00.6yr ⋅ hbgsrjnyrmeBHT ⋅ r/Multicopter
New AIO cam case+mount for my SCX200 LowPro. Minor tweaks and new angle... bring on the weekend!6yr ⋅ hbgsrjnyrmeBHT ⋅ r/fpvracing
You don't realise just how small these are until they are in your hand...6yr ⋅ hbgsrjnyrmeBHT ⋅ r/Multicopter
Hey BrotherHobby, what did you use to make the base plate of the T2? Alfoil? This is the third one!7yr ⋅ hbgsrjnyrmeBHT ⋅ r/Multicopter
Brisbane, the QLD national qualifier is on today. Come on down to Whites Hill.5yr ⋅ hbgsrjnyrmeBHT ⋅ r/Multicopter
More QX7 mods - added a pre arm button and reversed the default position of my arm switch.6yr ⋅ hbgsrjnyrmeBHT ⋅ r/Multicopter
It's taken a while but I've finally finished updating my 2 quads. Feels good to have 2 that are the same. Bring on the weekend!6yr ⋅ hbgsrjnyrmeBHT ⋅ r/Multicopter
Flight controller not connecting, I think it's touching some carbon.7yr ⋅ hbgsrjnyrmeBHT ⋅ r/Multicopter
Ultimate 2 stops printing due to filament kink. Any suggestions on how to prevent it?6yr ⋅ hbgsrjnyrmeBHT ⋅ r/3Dprinting
