Rapido HF has been clogging a lot and I can’t figure out why. Each time there’s this little disc in the filament as if it expanded into a crevice it shouldn’t have. Going to take it apart tomorrow morning for a better look, any guidance would be wonderful. ABS at 230, hotend fan running at full. TIA
I’ve created my first 3d printed abstract art. But now what’s the best way to remove it from the extruder and never do it again? Guessing maybe z was too high and/or the print bed wasn’t allowed to heat soak? Only my 3rd print on my 2.4, still dialing things in. Didn’t see the first layer go down :(
