Milled some Eastern Red Cedar/Juniper the other day. Used my 661 and 3 foot granberg milling attachment.11mo ⋅ ExploringWoodsman ⋅ r/slablab
My very simple Alaskan mill kinda setup i use for making slabs. Currently sawing with Solo 639 1.9kW 39cc saw. Goes nice and slow in softwoods at least up to 181yr ⋅ Jaska-87 ⋅ r/slablab
Does hand-slabbin' count? I didn't expect it to work, but I split a 2' wide maple log. Not sure what the next move should be.2yr ⋅ chocolatedessert ⋅ r/slablab
Stihl 880 with Max Flow and Barkbox. 47” bar on 48” Granberg mill. 32”-36” red oak slab. 8’ long.3yr ⋅ cpasawyer ⋅ r/slablab
Got some slabs off of the stump of the elm I cut for my family. The biggest one (the one leaned against me) is 40 inches wide at the widest point. Time to let them air dry for 3 years!2yr ⋅ ExploringWoodsman ⋅ r/slablab
My second attempt milling black walnut with my early 90s McCulloch Timberbear.4yr ⋅ ccstew ⋅ r/slablab
Thought I'd share my similar mills to a post by u/jaska-87 yesterday. We must think alike.1yr ⋅ motrboatmygoats ⋅ r/slablab
How does this look? Beginner at chain sharpening and don't know what to look for1yr ⋅ DifficultBoss ⋅ r/slablab
Went to the knife page first, a few folks thought it was neat. Hopefully translates into some interest in our shared hobby. u/cpasawyer, look what came in this morning.4yr ⋅ azuredianoga ⋅ r/slablab
I used the same rails as my slab starter to make a giant router plane to level stuff too big for the Dewalt 735x.4yr ⋅ azuredianoga ⋅ r/slablab
What type of moisture meter is better? Pin or contact less? Is this Klein one any good? Looking for recommendations?11mo ⋅ motrboatmygoats ⋅ r/slablab
Constance, the MS461 with a load of 14' 1-inch Ash boards for the roof sheathing4yr ⋅ iandcorey ⋅ r/slablab
I got this mill from a friend of mine. It’s been untouched for 5 years. Anyone have any wisdom on the make? Or any thoughts on what to do as far as cleanup?4yr ⋅ someothatjinglejangl ⋅ r/slablab
A question was asked about the first cut. Other folks might have different methods, but here's how I do it.4yr ⋅ azuredianoga ⋅ r/slablab
