Came home from work after a 20hr print to find it cracked all over. Any ideas what caused this?4yr ⋅ RangerBert ⋅ r/Ask3D
What do you supposed went wrong? I fell asleep during the print and not only did it spaghetti, it also moved from the center of the print bed5yr ⋅ Randompeanut1399 ⋅ r/Ask3D
I tried to replace the nozzle on my printer and it sheared. Any advice on removing the threading remaining in there?3yr ⋅ Dradiation ⋅ r/Ask3D
Hotend suddenly stops heating in the same pattern as before. See comment for more information.3yr ⋅ 1studlyman ⋅ r/Ask3D
Any idea to what could be happening? Modix Big-120X, 1mm nozzle. First few layers turn out great, but then starts getting droopy and bubbly.4yr ⋅ WorldsOkayestGolfer ⋅ r/Ask3D
Creality Cr-10 0,6 layer PLA 200C 60C Cura 3.4 slicer . A lot of layers are not sticking. I’m really noob at printing. Any place were to start solving issues?6yr ⋅ jaznow ⋅ r/Ask3D
What is wrong with my 3D printer? the first few layers come out like this, and then the rest is fine7yr ⋅ bodaciousbum ⋅ r/Ask3D
Printing UI Cura 15.04.02 Problem. How can i return this to the other uI?7yr ⋅ Silly_Ghillie ⋅ r/Ask3D
I've never had this problem before, just started happening today. What's causing it?7yr ⋅ tilerthepoet ⋅ r/Ask3D
This always happens,what can i do? The nozzle just picks up the lower layers and creates this mess7yr ⋅ nimawi ⋅ r/Ask3D
Anyone know a fix for this!? Anywhere there is I fill inside of my prints it shows on the outside.7yr ⋅ lukecov ⋅ r/Ask3D
Recently I repaired a P3Steel Pro And when I conected to the 12V to the ramps, It started nominally and then a minute or so started to make smoke.7yr ⋅ MrWilliam932 ⋅ r/Ask3D
Having issues with my first layer peeling off the bed. I've tried brims, and rafts. Any idea why this is happening, or how I can avoid it? It's causing the bottom of the print to be warped.8yr ⋅ TasteOfJace ⋅ r/Ask3D
